top of page
Search
Writer's pictureAbode Strata

4 Step Guide to Curing your home after Water Damage

Updated: Mar 21, 2019


Our insurance partners at Strata Community Insurance have created a handy 4 step guide to keeping your property habitable after water damage.


 

Step 1 - Ensure the site is safe!


Electrical - If any water has gone over electrical boxes, power outlets, or any other switches, you will need an electrician. In most modern buildings, the wiring is insulated and will not require replacement. *However, residual water (even a drop) in a power outlet can cause arcing* and can prove harmful.

Plumbing – Water may be categorised as follows:

o Category 1: Known as ‘Clean water’ which does not pose a substantial threat to humans;

o Category 2: Known as ‘Grey water’ which may contain contaminants and may cause discomfort or sickness to humans; or

o Category 3: Known as ‘Black water’ which contains bacteria that are harmful to humans.



Arcing is where an electric current is able to breach, reach or is conducted between positive and negative points. This creates an active circuit. In the case described the water acts as the conductor and is active. Stepping into water that conducts electricity may cause a shock.

You need to consider the type of water that has inundated the property, as the clean-up process associated with each type will differ. A bathtub that overflows, for example, would be clean water and the resultant damage – such as to carpet – would simply require water extraction, cleaning and sanitisation. In more severe cases, drying equipment will be used to artificially dry the carpet and subfloor, assisting in restricting mould growth. Carpet that is affected by black water, on the other hand, should not be salvaged. The best action plan in the case of black water would be to remove the carpet, clean and sanitise the floor, and replace the carpet.

HINT: Rainwater is Category 1; Rainwater runoff through urban areas is Category 2; Flood waters are Category 3; Salt or Brackish water are Category 3.

Structural integrity – a building will generally suffer some form of integrity issue when inundated with water. This may be as simple as plasterboard bowing, or may extend to long term rot or rust to framing, or even in extreme cases, to failure of foundations.



Step 2 - Remove all the water

Extract water from internal areas, such as basements, common areas, from common carpets, etc. In relation to lots, while these are not necessarily the Body Corporate’s responsibility, Strata Community Insurance suggests that all lots should be inspected for any sign of water after any significant event, as even the smallest amount of water may lead to mould growth – which will then become the Body Corporate’s responsibility. In the case of water inundation, lot owners should also contact their respective contents insurers immediately


NOTE: Water extraction may require specialised equipment such as wet vacuums or sump pumps. While Strata Community Insurance understands the ‘desire to help’ from members of the Body Corporate, we cannot stress enough that the safety of individuals is always of paramount importance, and that full instruction and supervision should be maintained by a qualified/experienced tradesperson



Step 3 - Mitigate the chance of mould

Moisture is the main issue here, and there is a tendency for people to want to artificially dry buildings. However, this is not the correct action in all cases. The success of artificial drying will vary, and is dependent on other factors (including climate). Conversely, artificial drying has been known to cause cracking and movement. Again, expert assistance should be sought before using artificial drying techniques, as natural drying may be more appropriate depending on the circumstances.


NOTE: Mould requires organic matter for food, moisture, warmth and oxygen. The removal of one (or more) of these will inhibit mould growth. Therefore, cleaning and ventilation are your keys to mitigating mould.


Step 4 - Repair the building

This part of the process may be long and tedious. Some parts (items within the building) will dry, require cleaning and will be perfectly functional irrespective of the categorisation of the water or degree of inundation.

The following items can be cleaned, dried and restored:

Concrete slabs & walls

Timber & metal framing

Most new electrical wiring.

Hot water systems; domestic models that are submerged are not repairable, whereas some commercial models can be cleaned, dried and restored.

Domestic appliances – Once submerged, are not repairable.


If you have found this guide helpful then click here for more information on SCI's Coverage Policy

18 views0 comments

Comments


bottom of page